Voltive 14/2 Speaker Wire - 14 AWG/Gauge 2 Conductor - UL Listed in Wall (CL2/CL3) and Outdoor/In Ground (Direct Burial) Rated - Oxygen-Free Copper (OFC) - 100 Foot Spool - Black

Easy to work with, great quality. Pure copper strands inside and nice strong insulation. Outer insulation is pretty easy to strip without cutting the inner insulation thanks to a think paper-ish sleeve in between.Stays in place well once installed (I used it inside a small sports car to wire up my front speakers to an under-seat amp).I was surprised how thick the whole contraption is. The two 14 AWG wires fit side by side inside the round outer insulation, which has a little room for air in it too and is pretty easy to squish flat where needed. It all worked out, but I kinda wish I’d done a little more research and gotten 16 or even 18 AWG/2 instead for this job, at the 14 gauge is simply overkill for my application.

Excellent speaker wires, easy to route in the wall and attic. this is a great value for the money.

Installed outdoors, seems like good jacket, we will see how long it last.

I installed a 7.1 sound system and this was great for all those wires that had to be pulled through the walls. The wire gauge specification was correct, the wires were flexible enough for the job, stripping was straightforward. The spool made pulling wires easy, just hang it so that it freely turns. What more could you ask for?

As a retired audiophile, I’ve always gone for the highest grade cabling / wiring. I used to spend outrageous amounts of money on expensive MIT gear. One tri-wire set with filters was $1,000 a foot. Honestly, this cable does an absolutely terrific job, literally at a fraction of the cost. It is easier to work with, easier to hide and sounds terrific. You can’t go wrong with this speaker wire. Do buy the thickest gauge that will work for you, depending upon the run lengths - the longer the run, the thicker the gauge required.

Using this to wire up my A/V unit in my living room. The wire is a nice thick gauge and all copper, letting me get a strong signal in the mounted speakers. Additionally, having an outer sheathing makes routing it easier and cleaner since it's 1 wire. It does make cutting/stripping them slightly more difficult, but well worth how beefy they are especially when the strands are twisted together.

Lay this out in the sun for a few minutes and the coil (Since it comes on spool) goes away. Thick outside to protect the wire. Will order again.

The wires ends tinned great per Kevin at Skylab recomendation