Coated Sand Casting Cast Iron Fireplace Ash Dump Door

Good quality, good value fireplace ash dump cover. I Used this to replace a decades old cover that had broken. It fit the opening and works well. Be sure to check fireplace measurements carefully.

Top side of the lid is weighted underneath so it closes easily and stays closed unless you specifically push to open the lid.Larger diameter rod supports on each side of the lid, and the heavier weight of the lid, make the lid quite secure so it is less likely to accidentally flip off the frame.Good lid seal when it is closed because the lid is a good fit and because the edges of the frame go underneath the sides of the lid.

Fits perfectly and works well.

The only downfall on this Ash dump is that where the tray door rod's attach to the frame the block receptacle for the rod is way overextended on the outside frame like 1/2inch of extra steel on each side of those blocks and will contact the floor if you dont have a lot of blow out at both ends of your hole those blocks need to be cut back a bit to get it in properly. I cut them back and recoated that section with a high heat coating and it's good to go, just beware if you're not able to modify them yourself it may not fit in the hole flush.

I needed to replace this in my fireplace and it was easy to just place it where the old one was .

Works great as a replacement for my old fireplace ash door. I have a 60 year old fireplace and I can only imagine this bottom ash door in it hadn't been replaced before now. Fits and looks great. Has held up perfectly to a few fires all ready, the type I burn at least a dozen large pieces of almond firewood each night.

It fit perfectly and I am happy with it except if the page said it was made in China I would never have bought it Amazon needs to tell where every product is made!

Fit my old fireplace perfectly, I'm super happy.