Klein Tools 89552 Hole Cutter, Adjustable Cutter from 2 to 12 Inch, Cuts 24 Gauge Steel and 26 Gauge Stainless

This is a great cutter for sheet metal and plastic. That’s what I’ve used it for so far without issue. It works great with a variable speed battery powered drill and I think it’s a great deal for the low price.

Works great I wish I had it a long time ago

This worked ok like a Klein tool but seemed to cut slower then I would have expected. I cut 5 - 10" holes and it did cut consistently the same. The speed of cut could have been due to the speed of the drill I was using. It's a solid tool like most Klein.

High quality item, drill bit cuts very quickly and comes with a spare.

I was skeptical......but it worked flawlessly......excellent tool!

the tool is pretty solid but the bits are not that good used 1 bit 12 times than dull started to use the 2nd bit today cut out 2 circles and the bit snapped have had this roughly 3 mo and not buying the bits for it to expensive so basically a junk tool

I knew I had to cut 8 new 6" duct takeoffs for my finished basement and I was not looking forward to it. So I went looking for a tool to reduce my likely frustration. I did not want to spend a ton since I was going to be doing this hundreds of times, but I wanted it to work. I think this tool hits the sweet spot of cost vs performance. It is simple to use and takes about 2 minutes or so to cut a hole. It makes a super clean hole, with only the last 1/8" or so needing to be cut with a snip tool (or bent back with pliers). Its also nice that the tool helps keep your hand away from the cut edges. Would buy again.

Used to cut hole for 6” recessed lighting in sheet metal ceiling. Much better than holesaw or any other method I have tried. Clean cuts but did take a couple of bits for around 20 6” holes. Would definitely recommend!